300Tdi Discovery
76
CHASSIS AND BODY
2
REPAIR
FRONT DOOR TRIM PANEL
Service repair no - 76.34.01
Remove
1. Remove the two securing screws and detach the
door pull from its mounting brackets on the inner
door panel.
2. Remove the interior door handle finisher button
to reveal the screw retaining the handle
surround.
3. Remove the screw and detach the handle
surround from the trim panel.
4. Where applicable remove the window winder.
5. Detach the trim panel by inserting a trim panel
removing tool between the trim panel and the
inner door panel, gently prise out the fourteen
plastic securing clips from their respective holes
in the inner door panel.
6. Disconnect the two speaker connections from
inside the door and remove the trim panel
complete with speaker, and door bin.
7. If a new trim panel is to be fitted, remove the
speaker, door bin and remote button finisher
from the existing trim panel and fit them to the
new panel.
Refit
8. Reverse removal procedure.
FRONT DOOR GLASS AND REGULATOR
Service repair no - 76.31.45
Remove
1. Ensure the window is in the fully closed position
and secure with adhesive tape to prevent the
window from dropping down.
2. Disconnect battery negative lead.
3. Remove the door trim panel.
See front door
trim panel.
4. Remove the plastic vapour barrier.
5. Where applicable remove the window lift motor.
See ELECTRICAL, Repair, window lift motor
- front.
6. Remove the four window regulator retaining
screws and shakeproof washers from the inner
door panel.
7. Remove the two screws and shakeproof
washers retaining the lower window lift channel,
and slide the channel off the stud.