300Tdi Discovery
CHASSIS AND BODY
21
REPAIR
REAR DOOR GLASS
Service repair no - 76.31.21
Remove
1. Remove the spare wheel from the rear door.
2. Remove the rear door wiper arm.
See WIPERS
AND WASHERS, Repair, wiper arm - rear
window.
3. If the glass is fitted, disconnect the heater leads
from the terminals, push out the glass and
remove the mounting rubber.
Refit
4. Thoroughly clean the opening to be glazed.
5. Clean the glass and fit the mounting rubber,
ensuring that the glass sits correctly in the
groove.
6. Fit a draw cord around the exterior of the
mounting rubber with the tails of the cord
situated on the top corner of the bend at the
bottom of the glass.
7. To aid assembly, coat the glass opening in the
door with liquid soap.
8. Position the assembled glass and rubber
mounting to the opening, with the tails of the
draw cord fed into the interior of the vehicle.
9. With assistance from a second operator, pushing
the glass and mounting rubber into the opening,
pull the draw cord from the mounting rubber
enabling the seal to ride up over the retaining
flange.
10. Connect the heater leads to the terminals on the
glass.
