300Tdi Discovery
CHASSIS AND BODY
41
REPAIR
SUNROOF ASSEMBLY - MANUAL, FRONT AND
REAR
Service repair no - 76.83.01
Remove
1. Close sunroof.
2. Remove headlining.
See headlining.
3. Remove screws and manual regulator from
clamping frame.
See sunroof regulator
manual.
4. Disconnect drain tubes from each side of
clamping frame.
5. Remove 13 screws and clamping frame from
upper frame.
6. Remove upper frame assembly from roof
aperture.
Refit
7. Position upper frame assembly into roof
aperture.
8. Locate clamping frame and reconnect drain
tubes.
9. Loosely fit screws, centralise upper frame and
clamping frame assemblies and then tighten
screws.
10. Reverse removal procedure.
Sunroof components
1. Glass panel
2. Capnut and washer
3. Screw
4. Upper frame assembly
5. Clamping frame assembly
6. Screw
7. Edging trim
8. Drain tube