300Tdi Discovery
HEATING AND VENTILATION
3
REPAIR
Air direction
3. Set control fully clockwise
4. Release outer cable from 2 clips on unit.
5. Release cable from stud on flap lever.
6. Remove control cable from control lever.
Temperature
7. Set RH control fully clockwise, LH control fully
anti-clockwise
8. Release outer cable from 2 clips on unit.
9. Release cable from stud on flap lever.
10. Remove control cable from control lever.
Refit
11. Reverse removal procedure. Check the
satisfactory function of the controls before fitting
louvre vent panel.
RESISTOR UNIT
Service repair no - 80.20.17
Remove
1. Open glove box, manoeuvre side springs
through cut-outs and lower lid.
2. Remove 2 screws securing resistor unit to
trunking.
3. Disconnect multiplug and remove resistor unit.
Refit
4. Reverse removal procedure.
