300Tdi Discovery
ELECTRICAL
5
REPAIR
ELECTRONIC IGNITION - V8i
A Lucas 35DLM8 distributor is employed. This has a
conventional vacuum advance unit and centrifugal
automatic advance mechanism.
A pick-up module, in conjunction with a rotating timing
reluctor inside distributor body, generates timing
signals. These are applied to an electronic ignition
amplifier module mounted on side of distributor body.
NOTE: Pick-up air gap is factory set. Do
not adjust gap unless pick-up is being
changed or base plate has been moved.
Use a non-ferrous feeler gauge to set air gap.
IGNITION COIL
Service repair no - 86.35.32
Remove
1. Disconnect battery negative lead.
2. Noting their fitted positions, disconnect electrical
leads from ignition coil.
3. Remove two bolts securing ignition coil clamp,
recover suppressor.
4. Remove coil.
Refit
5. Reverse removal procedure.
DISTRIBUTOR - V8i
Service repair no - 86.35.20
Remove
1. Disconnect battery negative lead.
2. Disconnect vacuum hose.
3. Remove distributor cap.
4. Disconnect low tension lead from coil.
5. Mark distributor body and centre line of rotor
arm.
6. Add alignment marks to distributor and front
cover.
NOTE: Marking distributor enables
refitting in exact original position, but if
engine is turned while distributor is
removed, complete ignition timing procedure
must be followed.
7. Release distributor clamp and remove
distributor.