300Tdi Discovery
86
ELECTRICAL
46
REPAIR
STARTER MOTOR - 4.0 V8
Service repair no - 86.60.01
Remove
1. Disconnect battery negative lead.
2. Raise vehicle on ramp.
3. Remove heated oxygen sensor from RH front
exhaust pipe.
See EMISSION CONTROL,
Repair, Heated Oxygen Sensor (HO2S) - 4.0
V8
4. Mark front propeller shaft and drive flanges for
assembly reference.
5. Remove 4 nuts and bolts securing propeller
shaft flange.
NOTE: Raise 1 front road wheel and rotate
propeller shaft to gain access to all
fixings.
6. Tie propeller shaft aside.
7. Position starter motor heat shield above motor.
See Starter Motor Heat Shield - 4.0 V8
8. Disconnect Lucar from solenoid.
9. Remove nut securing feed wires to starter
solenoid and disconnect from terminal.