300Tdi Discovery - 86 - Rear Window Lift Motor Repair
ELECTRICAL
27
REPAIR
WINDOW LIFT MOTOR - FRONT
Service repair no - 86.25.04
Remove
1. Ensure that the window glass is in its fully closed
position and secure it with adhesive tape.
2. Disconnect battery negative lead.
3. Remove the door pull, trim panel, and plastic
vapour barrier.
See CHASSIS AND BODY,
Repair, Front Door Trim Panel
4. Release the window lift motor wiring harness
from the three retaining clips to allow the
harness to be pulled out of the opening at the
front of the inner door panel.
5. Disconnect the window lift motor harness
multi-plug from the main door harness.
6. Support the motor, remove the three securing
bolts and withdraw the motor through the top
front opening of the door panel.
Refit
7. Reverse removal procedure.
NOTE: Ensure drive gear is engaged and
correctly aligned with window lift linkage
before fitting securing bolts.
WINDOW LIFT MOTOR - REAR
Service repair no - 86.25.09
Remove
1. Ensure that the side door glass is in the fully
closed position and secure with adhesive tape.
2. Disconnect battery negative lead.
3. Remove the door pull, trim panel and plastic
vapour barrier.
See CHASSIS AND BODY,
Repair, Rear Side Door Trim - Panel
4. Disconnect the lift motor harness multi-plug from
the door harness.
5. Support the motor and remove the three
securing screws.
6. Withdraw the motor through the lower opening in
the inner door panel.
Refit
7. Reverse removal procedure.
NOTE: Ensure drive gear is engaged and
correctly aligned with window lift linkage,
before fitting securing bolts.