Discovery I (LJ) V8-3.9L (1994)
NOTE:
The front cover bolts/studs enter into an oil pressure cavity, so sealing is critical. Do not use a thread locking compound. Use a thread sealing
compound such as Loctite(R) # 545, # 567.
5.
Apply thread sealing compound to the front cover bolts/studs.
6.
If Range Rover, install front cover studs.
7.
Position oil pan and finger-tighten bolts.
8.
Tighten bolts progressively in two stages in the sequence shown in figure 6.
^
Tighten to 10 Nm. (71 lbf ft.)
^
Tighten to 25 Nm. (18 lbf ft.).
9.
If Range Rover, perform the following:
^
Raise lift and remove cross member support.
^
Lower lift.
10.
Install screw holding dipstick tube to valve cover.
11.
Refill engine with oil to the proper level.
12.
Start engine and check for leaks.