Discovery I (LJ) V8-4.0L (1996)
Seat Bottom Frame: All Technical Service Bulletins
Front Seat Trim Cover - Loose/Rattles
11/08/95
76/25/95/US
SUBJECT
Front Seat Trim Cover Adrift
MODEL
Discovery
AFFECTED VEHICLES
LP
LH
LJ 081991 - 163104
LD
DETAIL
The retaining clips for the drivers seat side cover may not hold the cover tightly, and as a result the cover and clips may rattle. Installation of new clips or
turn buckles correctly hold the cover and prevent the rattle from occurring.
ACTION REQUIRED
Upon customer complaint of the seat side trim rattling, install the new turn buckles by following the procedure below.
PARTS INFORMATION
AFU 3609L - Turnbuckle - 2 required.
AFU 7598L - Plastic Washer - 2 required.
Loctite 495 adhesive
PROCEDURE
1)
Remove trim cover.
2)
Remove original turnbuckles from seat frame and discard.
3)
Remove washers from trim panel and discard.
4)
Apply Loctite adhesive to washers AFU 7598L.
From the inside face of the panel locate the washer in the trim panel holes.
5)
From the outside face of the panel fit turnbuckles AFU 3609L through holes and snap into washers.
6)
Refit trim panel and lock in place by twisting turnbuckle.