Discovery I (LJ) V8-4.0L (1996)
/v8-4.0l/Page-637005.png)
7. Lubricate piston rings and gudgeon pin with engine oil.
8. Lubricate cylinder bores with engine oil.
9. Fit ring clamp to piston and compress piston rings.
NOTE: Connecting rods shown in final fitted positions.
10. Insert connecting rod and piston assembly into respective cylinder bore ensuring domed shaped boss on connecting rod faces towards front of
engine on RH bank of cylinders, and towards rear on LH bank of cylinders.
11. Fit big-end bearing caps and bearing shells.
12. Fit cylinder head(s).rings - remove
