Discovery I (LJ) V8-4.0L (1996)
/v8-4.0l/Page-697002.png)
CAUTION:
Ensure that the longer bolt LSZ100000 is used ONLY at the Discovery oil cooler pipe bracket location (See Figure 1, Location "A").
NOTE:
The new bolts incorporate a sealant patch and are fitted to V8 engines in production from the safe VINs.
If patch bolts are removed for any reason they must be replaced with new patch bolts or have Loctite(R) sealant applied upon assembly.
1.
If only replacing the four oil pan bolts to rectify a leak from this area, perform the following:
^
Remove the four old bolts (Figure 1 positions 12, 4, 5).
^
Hand tighten the new patch bolts.
^
Torque new bolts to 23 Nm (17 lbf.ft.) using the Engine Overhaul Manual sequence (Figure 1).
2.
If applying Loctite(R) on used oil pan bolts to rectify a leak from this area, perform the following:
^
Remove the four bolts (Figure 1 positions 12, 4, 5).
^
Thoroughly clean all bolts and oil pan area.
^
Apply Loctite(R) 577 to the bolt threads.
^
Install and torque four bolts to 23 Nm (17 lbf.ft.) using the Engine Overhaul Manual sequence (Figure 1).
3.
If sealing a Discovery 4.0 liter oil pan for leakage, refer to TIB 12/08/96/US and perform the repair noting the following enhancements:
