Discovery I (LJ) V8-4.0L (1996)
/v8-4.0l/Page-725002.png)
8. Position oil seal guide LRT-12-010 on crankshaft flange.
NOTE: Lubricant coating must cover seal guide outer surface completely to ensure that oil seal lip is not turned back during assembly. Position
oil seal, lipped side towards engine, on seal guide. Seal outside diameter MUST be clean and dry.
9. Install the oil seal [14] using tool LRT-12-091, see illustration in step 7. Remove seal guide.
10. Tighten rear main bearing cap to 90 Nm (66 ft. lbs.).
11. Install the oil pan.
12. Install the flywheel or flexible drive plate and ring gear.
