Discovery I (LJ) V8-4.0L (1996)
1. Air gap between pick-up limb and reluctor teeth must be set within specified limits, using a non-ferrous feeler gauge.
2. If adjustment is necessary, loosen two barrel nuts to set the air gap.
NOTE:
-
When original pick-up and base plate assembly has been refilled, air gap should be checked, and adjusted if necessary.
-
When fitting a new assembly air gap will require adjusting to within specified limits.
Amplifier Module
1. Before fitting module, apply MS4 Silicone grease or equivalent heat-conducting compound to amplifier module backplate, seating face on
distributor body and both faces of heatsink casting.