Discovery I (LJ) V8-4.0L (1996)
/v8-4.0l/Page-1030003.png)
Symptom:
Key will not come out of ignition.
1.
Verify that the key sticks.
2.
Obtain radio code and disconnect battery negative terminal.
3.
Recheck ignition lock operation.
4.
If the lock operates normally, the fault is electrical. The solenoid is receiving power. Refer to ETM for diagnosis.
5.
If the lock sticks, the fault is mechanical. Go to the replacement procedure.
SOLENOID REMOVAL
1.
Obtain radio code and disconnect battery negative terminal.
2.
Remove driver's side closure panel (six screws)
3.
Remove instrument pack trim (four screws).
4.
Remove steering column shroud (six screws).
5.
Remove the three bolts securing column tilt lever assembly to column. See Figure 2, Ref. 3.
6.
Remove lever and plastic release plunger from column. See Figure 2, Ref. 4.
7.
Disconnect and unclip ignition switch leads.
8.
Remove two screws securing switch to column. See Figure 2, Ref. 7.
9.
Remove switch
10.
Remove interlocking cam. Note the orientation of the cam. See Figure 4.
11.
Disconnect interlock solenoid lead.
12.
Remove two painted screws securing solenoid to column.
13.
Remove solenoid.
