Discovery I (LJ) V8-4.0L (1996)
/v8-4.0l/Page-1605001.png)
Clutch Slave Cylinder: Service and Repair
Replacement
REMOVAL
1. Evacuate clutch system fluid at slave cylinder bleed valve.
2. Disconnect fluid pipe.
3. Remove two securing bolts and withdraw slave cylinder and backing plate.
4. If dust cover is not withdrawn with slave cylinder, withdraw it from bell housing.
INSTALLATION
5. Withdraw dust cover and backing plate from slave cylinder.
6. Coat both sides of backing plate with Hylomar P232M waterproof jointing compound, or equivalent.
7. Locate backing plate and dust cover in position on slave cylinder.
8. Install slave cylinder, engaging push-rod through center of dust cover and with bleed screw uppermost.
9. Reconnect fluid pipe.
10. Replenish and bleed clutch hydraulic system, refer to Bleed Hydraulic System. See: Service and Repair
11. Check for fluid leaks with pedal depressed and also with system at rest.
NOTE: All flexible and pipe connections and joints should be tightened to 15 Nm
