Discovery I (LJ) V8-4.0L (1996)
/v8-4.0l/Page-1638008.png)
19.
To check axle shaft end play, mount a dial indicator using bracket # LRT-99-503 and rest pin in a loaded condition on the end of the axle shaft
(Figure 6).
20.
Install a suitable bolt to the threaded end of the drive shaft. Move shaft in and out and note the dial indicator reading. End play should be between
0.08 to 0.25 mm. (0.003 to 0.010 in.).
21.
If end play requires adjustment, remove snap ring, measure shim thickness, and fit an appropriate shim to give required end play.
22.
Remove bolt from axle shaft, install snap ring and dust cap.
23.
Install brake caliper and tighten bolts to 82 Nm (61 lbf. ft.).
24.
Make sure swivel housing drain plug is tight. Remove filler and level oil plugs (Figure 7). Fill to level plug with GL4 or GL5 gear oil. Replace
plugs and clean surplus oil from housing.
25.
Install road wheel, remove jack stands, and tighten lug nuts to 126 Nm (93 lbf. ft.).
26.
Operate foot brake to locate brake pads before road test.
Technical Service Bulletin # TEC5106963
Date: 980501
Drivetrain - Rear Stub Axle Oil Seal Leakage
05/01/98
51/06/96/US
*ISSUE 3*
SUBJECT
PRIDE - Rear Stub Axle Seal: New Part Introduction
MODEL
AFFECTED VEHICLES
LP
Discovery
LJ up to VA544303
Discovery
LJ up to VA714242
