Discovery I (LJ) V8-4.0L (1996)
/v8-4.0l/Page-1638019.png)
15.
Fit second hub nut and tighten to 50 Nm (37 lbf. ft).
16.
Lock both inner and outer nuts with locking tab washer.
17.
Install new gasket on driving member and install driving member to hub. Secure with five bolts. Tighten to 65 Nm (48 lbf. ft).
18.
Install original axle shaft shim and secure with snap ring.
19.
To check axle shaft end play, mount a dial indicator using bracket # LRT-99-503 and rest pin in a loaded condition on the end of the axle shaft
(figure 6).
20.
Install a suitable bolt to the threaded end of the drive shaft. Move shaft in and out and note the dial indicator reading. End play should be between
0.08 to 0.25 mm. (0.003 to 0.010 in.).
21.
If end play requires adjustment, remove snap ring, measure shim thickness, and fit an appropriate shim to give required end play.
22.
Remove bolt from axle shaft, install snap ring and dust cap.
23.
Install brake caliper and tighten bolts to 82 Nm (61 lbf. ft).
24.
Make sure swivel housing drain plug is tight. Remove filler and level oil plugs (figure 7). Fill to level plug with GL4 or GL5 gear oil. Replace
plugs and clean surplus oil from housing.
25.
Install road wheel, remove jack stands, and tighten lug nuts to 126 Nm (93 lbf. ft).
26.
Operate foot brake to locate brake pads before road test.
Technical Service Bulletin # TEC6001973
Date: 980814
Drivetrain - Front Axle Swivel Seals Leaking
08/14/98
60/01/97/NAS
*ISSUE 3*
SUBJECT
PRIDE - Front Swivel Seal Replacement and Grease Fill
