Discovery I (LJ) V8-4.0L (1996)
15.
Install brake caliper. Tighten bolts to 82 Nm. (61 lbf. ft.), and secure brake hose to axle housing.
17.
Push ABS sensor in until it touches sensor ring. Rotate hub to set sensor.
18.
Install road wheel and tighten lug nuts to 126 Nm. (93 lbf. ft.).
19.
Check axle fluid level and top up as necessary.
20.
Remove axle stands and lower vehicle.
WARRANTY:
Normal warranty policy and procedures apply
COMP.CODE:
SRO:
64.16.22 - Time 0.85 hr. each
Replace rear stub axle seal
Technical Service Bulletin # TEC540296
Date: 961231
Front Stub Axle Seal - Leaks Oil
12/31/96
54/02/96/US
SUBJECT:
PRIDE - Front Stub Axle Seal: New Part Introduction
MODEL:
Discovery
Defender
AFFECTED VEHICLES:
LP
LH
up to VA544303
LJ
up to VA714242
LD
up to VA102694
DETAIL
On 1994-96 Discovery vehicles the front stub axle oil seals may leak. The following procedure has been developed to replace it with an improved seal. If
the stub axle seal is observed to be leaking, the stub axle seal on the opposite side of the axle must also be replaced.
The diagnostic steps and repair procedures detailed in this bulletin were developed as an element of the Land Rover Way OPERATION PRIDE. This
TIB provides a library location for PRIDE information within the Land Rover North America technical literature system.
ACTION REQUIRED
Upon customer complaint for the symptoms outlined, perform the specified repairs.