Discovery I (LJ) V8-4.0L (1996)
/v8-4.0l/Page-1644002.png)
8. Clean hub and install inner and outer bearing races.
9. Pack hub inner bearing with grease and install to hub.
10. With lip side leading install a new seal flush with rear face of hub.
-
Using service tool LRT-54-003 seal replacer and drift.
-
Apply grease between seal lips.
11. Assemble brake disc to the hub, line up reassembly marks.
-
Applying Loctite 270, install and tighten retaining bolts to 73 Nm.
12. If necessary, where applicable, renew sensor ring studs applying Loctite 270 to threads.
-
Install sensor ring using new nylock nuts.
-
Tighten to 9 Nm.
-
Ensuring it is correctly installed to avoid tooth run out.
13. Pack hub outer bearing with grease and install to hub.
14. Install rear hub assembly, refer to Replacement.
