Discovery II (LT) V8-4.0L (2002)
/v8-4.0l/Page-1577006.png)
7.
Remove two bolts securing the front of the console.
8.
Move console rearwards approximately 15-20 mm (1/2 to 3/4 inch).
9.
Fit velour pads (STC3937) to recesses in fascia (B in Figure 3) and then move pad into position (A in Figure 3).
10.
Align console and install and tighten screws and bolts.
11.
Close the rear console lid.
12.
Secure selector panel and move selector lever to the "P" position.
13.
Install foam pad.
14.
Install transfer box lever gaiter and knob, secure gaiter.
PROCEDURE 5 - THIRD ROW SEATS RATTLES AND CREAKS
1.
Release the 3rd row seat from the stowed position.
2.
Remove the rubber buffer and refit in reversed position (from "A" to "B" in Figure 4)
3.
Remove backing from tape (STC3118K) and fit pad to the top and the underside of the hook on seat frame (See Figure 5).
