Discovery II (LT) V8-4.0L (2002)
/v8-4.0l/Page-1577012.png)
10.
Drill out the rivet and open out hole to fit an M6 bolt (arrowed in Figure 19).
11.
Insert a new bolt (supplied in kit HAK000010) with the head of the bolt on the outside of the seat frame, apply a thread lock compound and torque
to 14 Nm (124.3 lbf.in.).
12.
Apply grease to both mating surfaces of the rear cross-tube and wipe off excess. (Arrowed in Figure 20)
13.
Replace nut and washer (supplied in kit HAK000010), and torque to 19 Nm.
14.
Remove any weld spikes from the bearing surfaces.
15.
Using a flat-bladed screwdriver, create a 2-3 mm (1/8 inch) gap between the side channel and slide reinforcing bar. (Arrowed in Figure 21)
16.
Refer to RAVE section 78.30.01/81 and remove the front seat squab cover.
17.
Inspect the seat frame for evidence of paint removal caused by the trim wire contacting the seat frame. (A in Figure 22)
18.
Apply rattle tape to cover the marks on the seat frame or the area identified as B in Figure 22 as follows:
