Discovery II (LT) V8-4.0L (2002)
/v8-4.0l/Page-470002.png)
8. Disconnect Lucar from oil pressure switch.
9. Disconnect multiplug from CMP sensor.
10. Loosen union and disconnect oil cooler pipe from timing gear cover. Remove and discard 'O' ring.
CAUTION: Always fit plugs to open connections to prevent contamination.
11. Remove 9 bolts securing timing gear cover and remove cover. Remove and discard gasket.
Refit
1. Clean mating faces of timing gear cover and cylinder block. Clean dowels and dowel holes.
2. Fit new gasket, dry, to dowels in cylinder block.
3. Position tool LRT-12-090 on timing cover and oil pump drive gear.
4. Position timing cover to cylinder block and at the same time, rotate tool LRT-12-090 until drive gear keyway is aligned with the woodruff keyway.
5. Remove tool LRT-12-090
