Discovery II (LT) V8-4.0L (2002)
26.
Depress the plastic collar and disconnect the brake servo hose from the intake manifold. (Figure 6)
27.
Release the clip and disconnect the breather hose from the manifold. (Figure 6)
28.
Disconnect the vacuum hose from the manifold. (Figure 6)
29.
Release the engine harness from retaining clips on the bulkhead and position the harness aside. (Figure 6)
30.
Remove the two bolts securing the air pipe and coil mounting bracket to the manifold. (Figure 6)
31.
Loosen the two lower bolts securing the coil bracket sufficiently to allow the bracket to clear the manifold. (Figure 6)