Discovery II (LT) V8-4.0L (2002)
Front Steering Knuckle: Technical Service Bulletins
Steering - Steering Knuckle Specification Update
No:
60/01/02/NAS
Ref:
Issue:
1
Date:
08/09/02
Steering Knuckle Specification Change
AFFECTED VEHICLE RANGE:
Discovery Series II (LT)
From 2A754808 and
Repaired vehicle with new style steering knuckles
SITUATION:
SPECIFICATION CHANGE AND SPARE PARTS IDENTIFICATION
A component specification change that modifies the camber angle of front axle steering knuckles has been introduced in production. The new
components are NOT interchangeable with older specification knuckles.
RESOLUTION:
VERIFY CORRECT COMPONENTS ARE UTILIZED IN PAIRS
NOTE:
The new specification steering knuckles can be fitted on vehicles up to VIN 2A754807 also. However the new style knuckle must ALWAYS be
fitted in pairs to ensure the camber angle is the same on each side.
CAUTION:
Never mix old and new parts numbers on the same vehicle.
Due to an engineering specification change it has been necessary to modify the suspension camber angle. Whenever a steering knuckle is replaced for
any reason, it is vital that the correct replacement components are used for the repair. The repair procedure itself is unchanged.
PARTS INFORMATION:
FTC5116
Steering knuckle - Right Hand Up to 2A754807 Casting # HRC2877
TAX000040 Steering knuckle - Right Hand From 2A754808 Casting # TAX000060
FTC5117
Steering knuckle - Left Hand Up to 2A754807
Casting # HRC2878
TAX000050 Steering knuckle - Left Hand From 2A754808
Casting # TAX000070
WARRANTY CLAIMS:
Normal warranty policy and procedures apply.
Material allowance is included in labor operation.
REPAIR PROCEDURE
CAMBER ANGLE - SPECIFICATION CHANGE
NOTE:
A casting number is shown on each knuckle to identify the component. Inspection should always be undertaken to ensure only matched pairs are
installed.
The design of the steering knuckle casting has been altered to give a 30' (minute) change in the camber angle.
This change does not affect the repair or service procedure.