Discovery II (LT) V8-4.6L (2003)
Keyless Entry Transmitter: All Technical Service Bulletins
Keyless Entry - Remote Transmitter Button Splitting
No:
86/03/03/NAS
Ref:
Issue:
1
Date:
04/25/03
Remote Handset Button Split
AFFECTED VEHICLE RANGE:
Freelander (LN)
All
Discovery (U)
All
SITUATION:
DETERIORATED RUBBER BUTTON SPLITS
The material used to cover the lock and unlock buttons on remote handsets used with Discovery and Freelander models can be impacted by adverse
environmental influences. The customer may complain that the rubber has split or cracked.
RESOLUTION:
REPLACE BUTTON COVER MATERIAL
When the rubber button cover on the remote has split, perform the procedure outlined in this TIB to replace the cover.
PARTS INFORMATION:
AMR4892K
Handset kit
Qty 1 (Alternative YWX101060L)
WARRANTY CLAIMS:
86.77.89/33
Time 0.10 hrs.
Install handset kit components on remote.
FAULT CODE: D
Normal warranty policy and procedures apply.
Material allowance is included in labor operation.
REPAIR PROCEDURE
INSTALL PLIP REPAIR COMPONENTS
CAUTION:
Anti-static precautions must be observed when performing this procedure. (Land Rover Tool LRNA-STATK)
1.
Carefully insert a small flat bladed screwdriver into the cutout at the rear of the handset.
CAUTION:
Damage to the printed circuit board (PCB) inside the plip can occur if the screwdriver enters the handset too far.
2.
Gently pry the covers apart. (Figure 1)