Discovery II (LT) V8-4.6L (2003)
Sunroof / Moonroof Motor: Service and Repair
76.84.07 Motor - Sunroof
This procedure is applicable to the motor of both sunroofs.
Remove
1. Gain access to the sunroof motor:
-
For front sunroof motor, remove front stowage pocket.
-
For rear sunroof motor, remove headlining.
CAUTION: The sunroof must be fully closed before removing the sunroof motor.
2. Disconnect sunroof motor multiplug.
3. Remove 3 Torx screws securing motor to sunroof tray.
4. Remove sunroof motor.
Refit
1. Check sunroof motor timing notch (A) aligns with edge of microswitch (B). If motor is out of alignment, rotate counting wheel (C) to correct
position using an Allen key.
2. Ensure sunroof drive cables are in fully closed position.
3. Fit motor to sunroof frame.
4. Fit Torx screws securing motor to sunroof tray and tighten to 2 Nm (1.5 lbf.ft).
5. Connect sunroof motor multiplug.
6. Fit interior trim:
-
For front sunroof motor, fit front stowage pocket.
-
For rear sunroof motor, fit headlining.