Discovery II (LT) V8-4.6L (2003)
^* Carefully release the retainers and remove the seat backboard. (Figure 8)*
^
Remove the two Torx screws securing the seat release twist grip assembly. (Arrowed in Figure 9)
^* Release the twist grip assembly from between the frame brackets.
^
Remove the metal rod from the twist grip halves and set aside.*
NOTE:
The ferrule may be glued into position.
^
Release the ferrule and remove the pin securing the release strap. (Inset in Figure 9)
2.
Install a new release twist grip as follows:
^* Release the ferrule and remove the pin securing the release strap. (Inset in Figure 9)
^
Install the spring to the stationary half of the twistgrip (fitted with ferrule) and insert the metal shaft.
^
Position the rotating half of the twistgrip (without ferrule) onto the shaft.
^
Locate the spring into the positioning holes within the twistgrip halves. (Figure 10)
NOTE:
When the spring is correctly positioned and the twistgrips are aligned on the shaft, the release strap locating lugs ("A" in Figure 10) will be
aligned between the ferrule's cut-outs on the stationary half of the twistgrip ("B" in Figure 10).