Discovery II (LT) V8-4.6L (2003)
1.
Release the ABS sensor harness grommet from the inner fender valance and disconnect the multi-plug. (Figure 1)
WARNING:
Always support the vehicle on safety stands.
2.
Raise front of vehicle and support with stands.
3.
Remove the wheel and tire assembly.
4.
Pull the ABS sensor harness through the aperture into the wheel arch. (2 in Figure 2)
5.
Release the ABS sensor harness from the brackets on the inner wing valance, suspension turret and the front hub. (3 in Figure 2)
6.
Refer to RAVE/GTR section 70.12.10 and remove the front brake disc.
CAUTION:
The ABS sensor and the surrounding area must be clean to prevent contamination from entering the hub assembly.