Discovery II (LT) V8-4.6L (2003)
Ride Control Solenoid Valve: Service and Repair
Solenoid - Directional Control Valve - ACE
Solenoid - Direction Control Valve - ACE
Service Repair No - 60.60.24
Remove
1. Raise vehicle on a ramp.
2. Disconnect multiplug from solenoid.
3. Loosen cap securing solenoid to directional control valve.
4. Remove 3 bolts securing valve block to chassis, lower block sufficiently only to remove solenoid.
5. Remove cap securing solenoid to directional control valve and discard O-ring.
6. Remove solenoid from directional control valve and discard O-ring from base of valve.
Refit
1. Ensure solenoid and directional control valve are clean.
2. Fit new O-ring to base of directional control valve.
3. Fit solenoid to directional control valve, with arrow on solenoid pointing up and connector in correct position.
4. Fit new O-ring to solenoid securing cap. Fit cap to solenoid but do not tighten at this stage.
5. Fit 3 bolts securing valve block to chassis and tighten to 18 Nm (13 ft. lbs.)
6. Tighten solenoid securing cap to 11 Nm (8 ft. lbs.).
7. Connect multiplug to solenoid.
8. Lower vehicle.