Discovery II (LT) V8-4.6L (2003)
Shift Solenoid: Service and Repair
Solenoids - Shift Control Valves (MV 1 & 2)
Service Repair No - 44.15.45
Remove
1. Remove valve body assembly.
2. Remove 3 Torx screws securing lock-up solenoid valve assembly to valve body and move solenoid aside.
NOTE: This is to gain access to remove Torx screw and MV2 shift control valve.
3. Note their fitted position and disconnect multiplugs from shift control valves MV 1 and MV 2.
4. Remove Torx screw and retaining fork securing MV2 shift control solenoid valve to valve body. Note that the tag on the retaining fork faces
towards the valve body.
5. Remove shift control valve from valve body.
Refit
1. Clean MV2 shift control solenoid valve with lint free cloth.
2. Position MV2 shift control solenoid valve to valve body.
3. Position retaining fork, fit Torx screw and tighten to 8 Nm (6 ft. lbs.).
4. Connect multiplugs to both shift control solenoid valves.
5. Clean lock-up solenoid valve assembly with a lint-free cloth.
6. Position lock-up valve assembly, fit and tighten Torx screws to 8 Nm (6 ft. lbs.).
7. Fit valve body assembly.