Discovery II (LT) V8-4.6L (2003)
Fluid Filter - A/T: Service and Repair
Filter - Oil
Service Repair No - 44.24.07
Remove
1. Remove oil sump gasket.
2. Remove Torx screw securing oil pick-up tube and remove tube.
3. Remove 2 Torx screws securing filter to valve body and discard O-rings.
Refit
1. Clean filter and pick-up tube using a lint free cloth.
2. Fit new O-rings to filter.
3. Position filter and tighten Torx screws to 8 Nm (6 ft. lbs.).
4. Position ok pick-tip tube end tighten Torx screw to 8 Nm (6 ft. lbs.).
5. Fit oil sump gasket.