Discovery II (LT) V8-4.6L (2003)
5. Heat new ring gear uniformly to between 170 ° and 175 °C (340 ° and 350 °F).
CAUTION: Do not exceed this temperature.
WARNING: Take care when handling hot ring gear.
6. Locate ring gear on flywheel with chamfered inner diameter towards flywheel flange.
NOTE: If ring gear is chamfered on both sides, it can be fitted either way round.
7. Press ring gear on to flywheel until it butts against flywheel flange.
8. Allow flywheel to air cool.
Flywheel - refit
1. Fit flywheel and locate on 2 dowels.
2. Fit flywheel bolts.
3. Using assistance, restrain crankshaft and tighten flywheel bolts to 80 Nm (59 ft. lbs.).