L322 Range Rover System Description and Operation
BRAKES
DESCRIPTION AND OPERATION
70-35
System Specifications
Service
The servicing requirements for the handbrake lever and cable system are minimal. However, the handbrake cables
remain a serviceable item and will need to be periodically replaced. The cables will always be in tension due to the
automatic adjuster and this tension must be released in order to facilitate replacement. The process to achieve this is
as follows:
1 Lower handbrake to rest position
2 Release gaiter from centre console and roll back to expose lever assembly
3 Remove access panel from rear of centre console
4 Pull back equaliser until adjuster spring is fully compressed
5 Replace pin. A suitably sized pin of adequate strength (preferably steel) may be used
6 Replace cables
7 Remove pin. The pin may be removed with the handbrake in any position
8 Replace gaiter and rear access panel.
Lever Ratio
7.25 : 1
Max Travel
38
°
Max No of Teeth on Ratchet
16
Max cable travel
20 mm
Max Adjuster Travel
20 mm