Workshop Manuals Factory service & repair Land Rover
01 Range Rover 2002MY ON Workshop Manual - Service Procedures - LM - 6th Edition - NAS02 03 04 05 06 07 08 09 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 INTRODUCTION26 27 28 GENERAL INFORMATION29 30 31 GENERAL DATA32 33 IDENTIFICATION NUMBERS34 35 TORQUE WRENCH SETTINGS36 37 LIFTING AND TOWING38 39 CAPACITIES, FLUIDS, LUBRICANTS AND SEALANTS40 MAINTENANCE41 42 ENGINE - V843 44 45 46 EMISSION CONTROL - V847 ENGINE MANAGEMENT SYSTEM - V848 49 FUEL DELIVERY SYSTEM - V850 51 COOLING SYSTEM - V852 53 54 55 MANIFOLD AND EXHAUST SYSTEM - V856 57 58 TRANSFER BOX59 60 61 AUTOMATIC TRANSMISSION - ZF 5HP2462 63 DRIVESHAFTS64 65 FINAL DRIVE66 67 68 FRONT DIFFERENTIAL69 70 71 72 STEERING73 FRONT SUSPENSION74 75 REAR SUSPENSION76 77 BRAKES78 RESTRAINT SYSTEMS79 80 81 82 DOORS83 EXTERIOR FITTINGS84 85 INTERIOR FITTINGS86 87 88 SCREENS89 90 91 SEATS92 93 94 SUNROOF95 BODY DIMENSIONS96 97 98 99 PANEL REPAIRS100 101 102 103 BODY SEALING MATERIALS104 105 106 107 CORROSION PREVENTION AND SEALING108 109 PAINTING110 111 HEATING AND VENTILATION112 AIR CONDITIONING113 114 115 WIPERS AND WASHERS116 CHARGING AND STARTING117 118 119 LIGHTING120 CONTROL UNITS AND RELAYS121 122 DRIVING AIDS123 124 ALARM SYSTEM AND HORN125 126 WINDOWS127 128 NAVIGATION AND IN CAR ENTERTAINMENT129 HARNESSES130 131 INSTRUMENTS
Land Rover L322 Range Rover Service Procedures107 · CORROSION PREVENTION AND SEALING
107 · General

Structural adhesive

Make
Land Rover
Model
Range Rover L322 Range Rover Service Procedures
Section
STRUCTURAL SEALING › Structural adhesive
CORROSION PREVENTION AND SEALINGStructural adhesive
Structural adhesive – Land Rover L322 Range Rover Service Procedures

CORROSION PREVENTION AND SEALING

-4

STRUCTURAL SEALING

Structural adhesive on body side frame - 
inner

Joints symmetrically opposite to those shown are also treated. Apply 3 mm diameter beads to all joints shown. Leave 

sill drain points free of adhesive.

Structural adhesive
Metal-to-metal adhesive is applied to critical joint areas during factory assembly. The material used is a high-
temperature, heat cured, nitrile phenolic which serves to bond two metal surfaces and also to seal the joint against 
ingress of dust, moisture and fumes. This material is not suitable for service use and, during repair, should be 
substituted by an approved Structural Adhesive.

Those joints which require the application of structural adhesive are detailed in the previous illustrations. Only joints 
applicable to service panels are included. Apply structural adhesive where indicated or to the mating panel surface.

CAUTION: When separating a joint treated with metal-to-metal adhesive, it is important to avoid distortion. 
Heat the joint gradually until the bond weakens sufficiently to permit panel separation.

NOTE: When spot welding through metal-to-metal adhesive, take particular care to adjust the transformer setting to 
ensure a reliable weld.

Parts & tools for this job For Land Rover Range Rover

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.