LR2 (LF) L6-3.2L (2008)
4.
Install T15 Torx screw and tighten to 2.5 Nm +/- 0.25 Nm (1.8 lbf-ft +/- 0.18 lbf-ft).
^
Repeat for the opposite side.
CAUTION:
Ensure the net deflector folds protrude rearwards when closing the roof opening panel glass. The net deflector is set to fold-up in one direction.
If it is reversed, the folds can protrude forwards and can get trapped between the seal and the glass, and could provide a water leak path.
5.
Switch ignition "ON".
6.
Close roof opening panel.
INITIALIZE ROOF OPENING PANEL MOTOR
1.
Manually initialize the roof opening panel motor:
^
Raise the roof opening panel glass to the full-tilt position.
^
Release the switch.
NOTE:
Do not release the switch until the roof opening panel has completed the open / close cycle.
^
Press and hold the front leading edge of the switch.
^
After 20 seconds, the roof opening panel glass will:
^
Stall in the tilt mode (causing a noise).
^
Perform a full open / close cycle.
^
Release the switch.
2.
Remove all protective tape.
VERIFY ROOF OPENING PANEL OPERATION
NOTE:
One-touch close is inoperable from the tilt position.
1.
Verify correct operation of the roof opening panel:
^
One-touch open (tilt and full-open).
^
One-touch close (from the full-open position). Tilt (from the full-closed position).
Disclaimer