LR2 (LF) L6-3.2L (2008)
/l6-3.2l/Page-1805007.png)
25. Remove the rear seat backrest cover and pad assembly.
26. Remove and discard the hog rings.
Installation
1. NOTE:
^
If a replacement rear seat backrest cover is to be installed, cut out holes for the head restraint guide tubes and center safety belt trim panel. Use
the existing rear seat backrest cover as a template. This also applies to the backrest squab foam.
^
Use hog ring pliers to close the hog rings. Do not use any other tool. The hog rings must be closed to overlap as illustrated.
^
Make sure that new hog rings are installed.
Using hog ring pliers, install the 13 hog rings.
2. Guide the rear center safety belt and lower anchor through the backrest cover.
