LR2 (LF) L6-3.2L (2008)
Knock Sensor: Service and Repair
Front Knock Sensor (KS)
Front Knock Sensor (KS)
Removal
NOTE: Removal steps in this procedure may contain installation details.
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
1. Raise and support the vehicle.
2. Remove the oil cooler assembly.
CAUTION:
^
Make sure that the mating faces are clean and free of corrosion and foreign material.
^
Mark the components to aid installation.
3. Remove the knock sensor (KS).
Torque: 20 Nm
Installation
1. To install, reverse the removal procedure.