LR2 (LF) L6-3.2L (2008)
Communications Control Module: Service and Repair
Bluetooth Module
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Remove the RH rear quarter trim panel.
CAUTION:
^
Make sure that the fiber optic cables are not bent to a radius of less than 25 mm.
^
Make sure that the optical connectors are clean and free of foreign material.
2. Torque: 10 Nm
Installation
1. To install, reverse the removal procedure.
2. If a new component is to be installed, configure using IDS.