LR2 (LF) L6-3.2L (2008)
/l6-3.2l/Page-110002.png)
5. Remove the sensor using grips or pliers.
Installation
1. Install the new gasket.
2. Install the new sensor.
3. Install the cupped washer to the sensor with the convex side against the sensor.
4. Install the new throttle valve.
CAUTION: Only use the specified material to lubricate the seals.
5. Lubricate and install a new O-ring seal.
NOTE: Lubricate the O-ring seal.
6. Install the active on-demand coupling module.
Torque: 6 Nm
7. Connect the 2 electrical connectors.
