LR2 (LF) L6-3.2L (2008)
Starter Motor: Service and Repair
Starter Motor
Starter Motor - Petrol
Removal
CAUTION: After switching of the ignition, wait for 2 minutes before disconnecting the battery. Failure to wait for 2 minutes will damage
the navigation computer.
1. Disconnect the battery ground cable.
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
2. Raise and support the vehicle.
3. Remove the engine undershield.
Installation
CAUTION: Make sure that the mating faces are clean and free of corrosion and foreign material.
1. Install the starter motor and tighten the bolts.
Torque: 45 Nm
2. Connect the cable and lead to the starter motor solenoid and tighten the nuts.
Torque: 10 Nm
3. Install the engine undershield.
4. Connect the battery ground cable.