LR2 (LF) L6-3.2L (2008)
Ride Height Sensor: Service and Repair
Rear Suspension Height Sensor
Service Repair No - 64.36.01
Removal
NOTE: This sensor is only fitted to vehicles with Xenon headlamps and is installed on the LH side of the vehicle.
NOTE: Removal steps in this procedure may contain installation details.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Remove the wheel and tire.
3. Torque:
10 Nm
Installation
1. To install, reverse the removal procedure.
2. Using Land Rover approved diagnostic equipment, calibrate the sensor.