LR2 (LF) L6-3.2L (2008)
Strut Cartridge: Service and Repair
Front Suspension
Front Shock Absorber (60.30.02)
Removal
WARNING: Ensure the spring compressor Safe Working Load (SWL) meets or exceeds the spring rating quoted in the Specifications.
WARNING: Always follow the spring compressor manufacturer's instructions.
1. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
2. Remove the road wheel.
3. Remove the spring and damper assembly.
4. Install the spring compressor in a vise.
5. Install the shock absorber and spring assembly in the spring compressor.
6. WARNING: Make sure that a new nut is installed.
Installation
1. WARNING: Make sure that a new nut is installed.
WARNING: It is imperative that the timing marks are aligned as shown in illustration.
Torque:
80 Nm
2. Release the tension from the spring and damper assembly and remove from the special tool.
3. Remove the spring compressor from a vise.
4. Install the spring and damper assembly.
5. Install the road wheel.