LR2 (LF) L6-3.2L (2008)
Trailing Arm: Service and Repair
Trailing Arm
Service Repair No - 64.35.46
Removal
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Remove the wheel and tire.
3.
4.
Installation
1. Install the trailing link.
2. Fit nuts, bolts and washers securing the trailing link to the body and hub, but do not tighten at this stage.
3. CAUTION: Nuts and bolts must be tightened with the weight of the vehicle on the suspension.
Support weight of vehicle on a jack at the rear hub.
4. Tighten the nuts and bolts.
Torque:
270 Nm
5. Install the wheel and tire.
6. Check and if necessary, adjust the rear wheel alignment