LR2 (LF) L6-3.2L (2008)
10. Clamp both halves of a suitable bearing separator around the inner bearing track and position the drive flange in a press.
Using the special tool, press the drive flange from the inner bearing track.
Special Service Tools: Remover/Installer, Wheel Hub
11. Remove the circlip from the wheel knuckle assembly.
12. Position the wheel knuckle assembly in a press and support on special tools. Special
Service Tools : Remover/Installer, Wheel Hub
Press the wheel bearing out of the wheel knuckle assembly using special tool.
Special Service Tools: Remover/Installer, Wheel Hub Bearing
Installation