LR2 (LF) L6-3.2L (2008)
Oil Pump: Service and Repair
Active On-Demand Coupling Oil Pump
Service Repair No - 51.30.02
Removal
1. WARNING: Make sure to support the vehicle with axle stands.
Raise the vehicle on the lift.
2. Remove the drive pinion flange.
3.
4. CAUTION: Be prepared to collect escaping oil.
CAUTION: Make sure that the area around the component is clean and free of foreign material.
Discard the O-ring seals.
Installation
1. CAUTION: Only use the specified material to lubricate the seals.
Lubricate the O-ring seals.
2. Install the new O-ring seals.
3. CAUTION: Make sure that the area around the component is clean and free of foreign material.
Install the oil pump.
Torque:
6 Nm
4. Connect the electrical connector.
5. Install the drive flange.
6. Check and top-up the active on-demand coupling fluid level.