LR2 (LF) L6-3.2L (2008)
Installation
1. WARNING: Make sure that a new nut is installed.
Using the special tool, install the drive flange.
Special Service Tools: Retainer, Drive Flange
Torque:
130 Nm
2. CAUTION: Make sure that new bolts are installed.
NOTE: Make sure that these components are installed to the noted removal position.
Install the driveshaft to the active on-demand coupling.
Torque:
40 Nm
3. Install the driveshaft rear support bracket.
Torque:
35 Nm
4. Check and top-up the active on-demand coupling fluid level.
5. Install the exhaust system.