LR2 (LF) L6-3.2L (2008)
Installation
1. Clean the components.
2. CAUTION: Take extra care not to damage the seal.
Install a new snap ring to the rear halfshaft and with assistance, connect the inner CV joint to the differential.
3. NOTE: The oil seal protector is designed to break into two pieces.
Remove and discard the rear halfshaft oil seal protector.
4. With assistance, install the rear halfshaft to the hub.
5. CAUTION: Only tighten the nut finger tight at this stage.
Install a new rear halfshaft nut, do not fully tighten at this stage.
6. CAUTION: Only tighten the nuts and bolts finger tight at this stage.
Connect both lower arms to the hub assembly, do not fully tighten at this stage.
7. CAUTION: Only tighten the nut and bolt finger-tight at this stage.
Connect the trailing arm to the hub assembly, do not fully tighten at this stage.
8. Secure the parking brake cable.
9. Support the weight of the vehicle using a jack under the rear hub.
10. CAUTION: Nuts and bolts must be tightened with the weight of the vehicle on the suspension.
Tighten both lower arm nuts and bolts.
Torque:
175 Nm
Tighten the trailing arm nut and bolt.
Torque:
270 Nm
Tighten the rear halfshaft nut.
Torque:
Stage 1. 330 Nm
Stage 2. 30 Degrees