LR3/Disco 3
7 .
Connect the upper arm and wheel knuckle.
Install a new nut and tighten to 70 Nm (52 lb.ft).
8 .
Secure the stabilizer bar link.
Tighten the nut to 115 Nm (85 lb.ft).
9 .
Connect the tie-rod end ball joint.
Install a new nut and tighten to 70 Nm (52 lb.ft).
10 .
Install a new halfshaft retaining nut and lightly tighten.
11 .
Secure the brake hose retaining bracket to the wheel knuckle.
Tighten the bolt to 25 Nm (18 lb.ft).
12 .
Secure the LH stabilizer link.
Tighten the nut to 115 Nm (85 lb.ft).
13 .
Tighten the halfshaft retaining nut to 350 Nm (258 lb.ft).
Stake the nut to the halfshaft.
14 .
Set the height distance between the centre of the halfshaft end and the edge of the fender trim to
466 mm (18.34'').
15 .
Tighten the lower arm bolts to 275 Nm (203 lb.ft).
Align the bolts to the marks made previously.
16 .
Install the RH lower arm. For additional information, refer to
Lower Arm (60.35.02)
(Section 204-01)