LR3/Disco 3
Installation
10 .
Using the special tool, release the upper arm ball joint.
Remove and discard the retaining nut.
11 .
Release the brake hose from the upper arm.
12 .
Release the wheel speed sensor lead from the upper arm.
13 .
Remove the upper arm.
1 .
Install the upper arm.
Fit the bolts but do not fully tighten at this stage.
2 .
Secure the brake hose to the upper arm.
Tighten the bolt to 23 Nm (17 lb.ft).
3 .
Secure the wheel speed sensor lead to the upper arm.
4 .
Connect the upper arm and wheel knuckle.
Install a new nut and tighten to 70 Nm (52 lb.ft).
5 .
Secure the stabilizer bar link.
Tighten the nut to 115 Nm (85 lb.ft).
6 .
Connect the height sensor link arm.