LR3/Disco 3
3 .
Install the RH upper arm.
Fit the bolts but do not fully tighten at this stage.
4 .
Secure the brake hose to the upper arm.
Tighten the bolt to 23 Nm (17 lb.ft).
5 .
Secure the wheel speed sensor lead to the upper arm.
6 .
Connect the upper arm and wheel knuckle.
Install a new nut and tighten to 70 Nm (52 lb.ft).
7 .
Secure the stabilizer bar link.
Install a new nut and tighten to 115 Nm (85 lb.ft).
8 .
Connect the height sensor link arm.
9 .
Set the height distance between the centre of the halfshaft end and the edge of the fender trim to
466 mm (18.34'').
10 .
Tighten the 2 upper arm nuts and bolts to 175 Nm (129 lb.ft).
11 .
Secure the heat shield.
12 .
Install the LH upper arm. For additional information, refer to
Upper Arm (60.35.01)
(Section 204-01)
13 .
Install the front wheels and tires.
Tighten the wheel nuts to 140 Nm (103 lb.ft).